Flush Valve

24V DC output to control a Flush Solenoid (maximum 36W). This output is active throughout the operation of any pump that is associated with that particular Flush Manifold.

Delay Time

Adjustable time period between a signal being acknowledged and a pump beginning its operation.

Run-Time

Adjustable time period for which a pump will operate.

Dosage

The volume of product which is required to be dosed into a wash cycle by each pump.

Pulse

Signal number that a pump is to operate on. Pulse counter returns to zero when the unit resets.

Reset Delay

Adjustable time period at the end of the wash cycle before the dispenser resets. The Reset Delay begins after the operation of the final pump (ie: Pump 8, on an 8-pump unit).

Relay

Operational mode allowing the pumps to run as if they were directly driven from the input signals.

Safety Stop

A sensor input used to detect the flow of water through a Flush Manifold.

Cycle Counters

Provides a record of the number of cycles and length of time that has been completed by each pump and program.

Pump Stop

Switch the pumps off in case of failure and to prevent operation during maintenance.

Signal

A trigger signal from the machine to notify of changes in cycle state.

Input

Input connector for signal coming in from the machine.

Pulse

Indicates the pulse signal coming in from the machine.

Machine Interrupt

Signal sent in from the machine to interrupt the unit of a change in state.

Auto Formula Select

For Nexus units that do not have a Formula Select module. Allowing signals to be sent from the Laundry Machine to select a specific program by either timed signals or based on this binary list.

Common Neutral

The common neutral connector for wiring trigger signals.

Isolated Neutral

The isolated neutral connector for wiring trigger signals.

Trigger Signal

The incoming signals from the washing machine.

Prime

When a pump is primed to draw the chemical up to the drum in preparation for running a program.

Total Wash Cycles

The sum of cycles a wash program has run on a Nexus unit.

Unit of Measurement

The unit that the programs calculate delivery of chemical. It can be ML, M:S, Grams and Fl. Oz

Inlet

The inlet for the pump where chemical is drawn up.

Outlet

The outlet for the pump where chemical is distributed.

Machine Inlet

The outlet for the pump where chemical is distributed.

Firmware Version

Is the firmware version installed on your Nexus unit.

Serial Number

The unique identifier number for your Nexus unit.

Flush Time

The time the flush valve will remain open during delivery time.